WAX3F RM-ED009 SERVICE MANUAL WAX3F CHASSIS MODEL MODEL COMMANDER DEST COMMANDER DEST KDL-40V3000 KDL-40V3000 RM-ED009 RM-ED009 KDL-46V3000 KDL-46V3000 RM-ED009 RM-ED009 KDL-40V3000 / KDL-46V3000 RM-ED009 FLAT PANEL COLOR TV - 1 -...
COMPONENTS IDENTIFIED BY SHADING AND MARKED THE SCHEMATIC DIAGRAMS, EXPLODED VIEWS AND IN THE PARTS LIST ARE CRITICAL FOR SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
Due to the higher melting point of Lead Free Solder the soldering iron tip temperature needs to be set to 370 degrees centigrade. This requires soldering equipment capable of accurate temperature control coupled with a good heat recovery characteristics. For more information on the use of Lead Free Solder, please refer to http://www.sony-training.com - 3 -...
WAX3F RM-ED009 CONNECTORS 21 Pin Connector (SCART) Pin No Signal Signal level Audio output B Standard level : 0.5V rms (right) Output impedence : Less than 1kohm* Audio input B Standard level : 0.5V rms (right) Output impedence : More than 10kohm* Audio output A Standard level : 0.5V rms (left)
Page 6
WAX3F RM-ED009 HDMI Connector Pin No Signal Assignment Pin No Signal Assignment TMDS Data2+ TMDS Clock Shield TMDS Data2 Shield TMDS Clock- TMDS Data2- TMDS Data1+ Reserved (N.C. on device) TMDS Data1 Shield TMDS Data1- TMDS Data0+ DDC/CEC Ground TMDS Data0 Shield +5V Power TMDS Data0- Hot Plug Detect...
Page 7
WAX3F RM-ED009 WAX3F SELF DIAGNOSTIC SOFTWARE The identification of errors within the WAX3F chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In the event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous flashing LED) and then communicate with each device in turn to establish if a device is faulty.
WAX3F RM-ED009 SECTION 3 SET-UP ADJUSTMENTS 3-2. Signal Level Adjustment 3-1. How to enter Service Mode Service adjustments to this model can be performed using the 3-2-1. Set up of AD calibration1 adjustment for supplied remote Commander RM-ED009. terrestrial analog. The following adjustments are done via ECS.
WAX3F RM-ED009 5. Read SREG_TCD3_SATURATION via ECS. 4. Read SREG_AVE_VAL_B_AREA6 via ECS 6. Restore the original value. SREG_NR = 4 (Auto). (READ_AREA = 6). 7. Send ECS command ADJUST_LEVEL_SETTING_CLR. 5. Confirm that 8 bits of MSB of item number 3) and 4) are within spec of the table below.
WAX3F RM-ED009 11. Wait for calculation in TV Micro. Offset Value C (This calculation value is “A”). 12. Calculate register SREG_G_GAM_IDX_OFST using the formula tmp75_temp 9100<tmp75_ 10368<tmp75 11136<tmp75 =<9100 temp=<10368 _temp=11136 _temp and tables below. 40" SREG_G_GAM_IDX_OFST = A - C tmp75_temp 9100<tmp75 10496<tmp75...
Page 17
WAX3F RM-ED009 7. Set up SREG_TEST_G_LEVEL = 76 (30 IRE). 8. Adjust SREG_WB_GAM_R(B)03 chroma values so that they are within tolerance in the table below. Tolerance 40" 0.1917 0.4327 0.0008->0.0014 46" 0.1906 0.4317 0.0008->0.0014 9. Set up SREG_TEST_G_LEVEL = 51 (20 IRE). 10.
WAX3F RM-ED009 3-4-3. White Balance of Colour Temperature “Neutral”, “Warm 1” and “Warm 2” The offset value for Color Temerature “Neutral”, “Warm 1”, and “Warm 2” is set in NVM Data as shown in the table below. Note: The offset values in the table below have been applied from NVM version “TD1009E”. (PKG version isPKG1016). 40"...
Page 30
D-IRO I r - S w i t c h R3276 VDDE R3226 POWER_INT C3071 HP_DET A23/P57 100p R3005 1/16W KEY_1 R3061 002:11K SP_SD A22/P56 JL1060 PINT 003:10F A21/P55 POWER_KEY 0 0 4 : 1 3 I R3274 A20/P54 100k JL3046 1/16W KEY1...
Page 44
BE1F 8D/14 THIS DOCUMENT IS THE PROPRIETARY PROPERTY OF SONY. ITS USE IS AUTHORISED ONLY FOR RESPONDING TO A REQ UEST FOR QUOTATION OR THE PERFORMANCE OF WORK FOR SONY. ALL QUESTIONS MUST BE REFERRED TO THE LOCAL PURCHASING DEPARTME NT OF SONY.
Page 46
BE1F.-WAX3F FE_+2V5_DDR BE1F PLACE THESE CAPACITORS CLOSE TO IC PINS. PLACE THESE CAPACITORS CLOSE TO IC PINS. 9B/14 C7219 C7228 C7227 C7226 C7225 C7224 C7213 C7214 C7215 C7216 C7217 C7218 C7220 100p 100p 100p 100p 100p 4 . 7 0 . 1 0 .
Page 47
BE1F.-WAX3F BE1F LAYOUT NOTE:- 9C/14 REMOVE GND PLANE AROUND AND UNDERNEATH IC7202 FE_+3V3 AND X7200 INCLUDING TRACKS FROM XTAL TO IC. FB7201 C7204 C7205 C7209 0 . 1 4 . 7 C7211 0.001 0 . 1 1005 3216 010:P10 BOARD VERSION RESISTORS - MOUNT ON TP7223 JL7210 SIDE-B WITH JL’S ON SIDE-B...
Page 54
BE1F.-WAX3F EMMA 1V5 REG IC7601 PQ070XNA1ZPH BE1F Cu Heatsink FE_+3V3 FE_+1V5 12/14 IC7600 NCP1117STAT3 - - - - - - - - - - - FE_+3V3 JL7601 Add 16mmx16mm area VOUT 1005 C7611 F7602 FB7603 C7603 GND/ADJ C7643 C7644 Connect to TAB of 0 .
Page 55
BE1F.-WAX3F UNREG6.5V BE1F 13A/14 FE_+5V_REG C6742 C6744 C6743 P l a c e o n A s i d e u n d e r T U 3 9 0 1 lOGIC AND VOLTAGE SWITCHING ET6700 FE_5VAEMI_F FE_5VAEMI FE_+3V3_DEMOD R6702 ET6701 C6741 C6740...
SECTION 5 EXPLODED VIEWS NOTE : Non-serviceable items with no part number and no Items marked “*” are not stocked since they are seldom required for description are not stocked because they are not required for routine service. routine service. Some delay should The construction parts of an assembled part are indicated be anticipated when ordering these with a collation number in the remarks column. items. 5-1. CHASSIS 2-580-606-01 SCREW, +PSW M5X8 2-580-600-01 SCREW, +PSW M4X8 2-674-965-41 SCREW, +PSW 3SG 3-252-830-01 SCREW, +PWHTP B3 Note : The components identified by mark contain confidential information. Strictly follow the instructions when ever the components are repaired and/or replaced.
Page 88
2-580-644-01 SCREW, +KTP2 3X8 5-2. REAR COVER, STAND & BEZEL 2-580-607-01 SCREW, +PSW M5X12 Ver3 Note: 2-580-607-01 Also used for securing stand to LCD-TV 2-580-608-01 SCREW, +PSW M5X16 m 2-580-629-01 SCREW, +BVST 3X8 7-685-648-79 SCREW, +BVTP 3X12 TYPE2 IT-3 2-580-640-01 SCREW, +BVTP2 4X16 REF.NO. PART.NO DESCRIPTION REMARK REF.NO. PART.NO DESCRIPTION REMARK *X-2187-437-1 STAND (ML) ASSY 40 inches X-2187-444-2 BEZEL ASSY (40) 40 inches *X-2187-438-1 STAND (L) ASSY 46 inches X-2187-445-4 BEZEL ASSY (46) 46 inches X-2102-511-3 BAG ASSY, RUDDER LOCK *A-1268-308-A H3 BOARD, COMPLETE 3-218-505-02 PLATE, U2 *A-1314-489-A H1 BOARD, COMPLETE 3-218-504-02 SHIELD, U2 3-106-544-01 BUTTON, MULTI *A-1506-079-A U2 BOARD, COMPLETE...
SECTION 6 ELECTRICAL PARTS LIST PARTS LISTING TABLE OF CONTENTS Page G3 BOARD COMPLETE Parts List : ....................91 BE1F BOARD COMPLETE Parts List : ....................94 U2 BOARD COMPLETE Parts List : ....................114 DF1 BOARD COMMON Parts List : Only fitted to 40”...
Page 128
BE1F.-WAX3F BE1F.-WAX3F TO U2 PWB RESER TO WX&TMDS341 BE1F BE1F 6A/14 6B/14 TO TAS *R5636 0 0 7 : 6 I ; 0 0 7 : 9 F ; 0 0 7 : 1 0 J GND_D CHIP RXC_2R- TMDS CLK- *R5599 CHIP 1005...
Page 129
FE_+3V3 8D/14 THIS DOCUMENT IS THE PROPRIETARY PROPERTY OF SONY. ITS USE IS AUTHORISED ONLY FOR RESPONDING TO A REQ UEST FOR QUOTATION OR THE PERFORMANCE OF WORK FOR SONY. ALL QUESTIONS MUST BE REFERRED TO THE LOCAL PURCHASING DEPARTME NT OF SONY.