Table of Contents
Advertisement
Excess signal input level
Specifies whether to display a warning via the ALERT
indicator when the signal input level detected is excessive.
ON/OFF
Low receiving signal quality
Specifies whether to display a warning via the ALERT
indicator when the quality of the received signal is low.
ON/OFF
Excess peak level for audio input
Specifies whether to display a warning via the ALERT
indicator when the audio input has been detected as
exceeding the peak level.
ON/OFF
Low transmitter battery
Specifies whether to display a warning via the ALERT
indicator when the remaining battery of the transmitter is
detected as low.
ON/OFF
Encryption mismatch
UNMATCH)
Specifies whether to display a warning via the ALERT
indicator when a mismatch between the encrypted
communication settings for the transmitter and the receiver
is detected.
ON/OFF
Unsynchronized with external sync signal
(EXTERNAL WORD SYNC UNLOCK)
Specifies whether to display a warning via the ALERT
indicator when synchronization with the external sync
signal (word clock) is not possible.
ON/OFF
Audio codec mode mismatch
UNMATCH)
Specifies whether to display a warning via the ALERT
indicator when an audio codec mode mismatch is detected
between the transmitter and receiver.
ON/OFF
Items Related to Display (DISPLAY
submenu)
Setting the brightness of the display
(BRIGHTNESS)
Ten levels of brightness can be selected for the organic
light-emitting diode display.
The selectable settings are the following:
(Dark) 1 2 3 4 5 6 7 8 9 10 (Bright)
(RF OVER)
(QL LOW)
(AF PEAK)
(TX BATTERY LOW)
(ENCRYPTION
(CODEC MODE
Automatic dimming of the display
MODE)
The organic light-emitting diode display can be set to dim
or turn off after a certain amount of time.
AUTO OFF: The display turns off after 30 seconds. The
display goes on again when you use any button/control.
AUTO DIMMER: The display dims after 30 seconds. The
display becomes bright again when you use any button/
control.
ALWAYS ON: The display stays on at the brightness
level set with the BRIGHTNESS function.
Resetting Parameters to Their
Factory Settings
All parameter settings can be returned to their factory
settings.
A message appears asking for confirmation. Rotate the jog
dial to select YES.
The receiver parameters are reset to their factory settings.
Displaying the Software Version
(VERSION)
The version of receiver software can be displayed.
30
(DIMMER
(FACTORY PRESET)
Advertisement
Table of Contents
