Samsung scx-4100 series Instruction page 2
Cartridge
Hide thumbs
Also See for scx-4100 series:
- Manual del usuario (169 pages) ,
- User manual (169 pages) ,
- Service manual (111 pages)
Advertisement
U Refill Toner Ltd., 305 Telsen Centre, Thomas Street, Birmingham, B6 4TN, United Kingdom
Telephone UK 0121 448 3561
Starter cartridge refill
Take out the 5 screws
urefilltoner.co.uk
Tel. UK 0121 448 3561
5. Screw spout onto bottle and wrap sticky tape around join of spout to ensure no leakage of toner.
6. Note worm gears at each end of a horizontal bar.
urefilltoner.co.uk
UK 0121 448 3561
You might find that the stirrer blade confuses you. It's a strip with
windows bonded to the same shaft that connects the two worm
gears. Pay no real attention to it. Focus on the worm gears being
just covered and the level being short of the foam gasket as
explained above. With the stirrer blade in play, the correct level
looks something like this.
7. CARE! A full bottle holds 3 times the toner you want to pour
in. Go little by little, stopping to even out the toner by shaking
the cartridge from side to side.
8. Hold finger firmly over end of spout, shake bottle for 10 seconds.
urefilltoner.co.uk
UK
0121 448 3561
shake
14. Put refilled cartridge back machine and wait a few moments
while it initialises.
1. Make sure cartridge is at fade-out point (see page 1,
paragraph 3)
2. Take out 5 screws.
3. At back, near handle, insert flat blade screwdriver between
two halves of cartridge.
4. Twist blade to free lugs,
lifting top half of cartridge
at
cartridge will come off,
exposing
compartment.
We're aiming for a toner level that just covers those worm gears
so we can't see any of their teeth. Here's the right fill level:
you'll see the toner level is just short of a foam gasket.
UK 0121 448 3561
9. Slowly spread a layer of toner along length of compartment.
10. Stop pouring and shake cartridge from side to side to even out toner.
11. Check the level as described in 6. Stop if there. Carefully put more in if not.
12. Place handle piece in correct position for
re-assembly. Note triangular teeth face
upwards.
13. Snap cover back on and screw down with
5 screws.
http://www.urefilltoner.co.uk
same
time.
Lid
toner
Lugs to be freed are in these holes. Repeat this
action to left of cartridge handle if necessary.
urefilltoner.co.uk
Page 2
urefilltoner.co.uk
of
Tel. UK 0121 448 3561
urefilltoner.co.uk
urefilltoner.co.uk
UK 0121 448 3561
Tel. UK
0121 448 3561
urefilltoner.co.uk
Tel. UK 0121 448 3561
Advertisement
