Confirmation Of Network Setting - Sony DVP-NW50 Service Manual
Hide thumbs
Also See for DVP-NW50:
- User manual (40 pages) ,
- Installation (4 pages) ,
- Dimensions (3 pages)
Table of Contents
Advertisement
1.
Confirmation of LAN Setup of the InWall
Unit
*
1
*1 InWall Unit:
• DVP-NW50, AC-NW50
1-1. Use the LAN Setup Diagnostics function of the
InWall Unit.
1. Turn the power on.
The HOME menu appears.
2. Press the "V" SELECT on the HOME Menu, then press the
"SETUP" SELECT.
The Setup Menu appears.
3. Press the "V" SELECT repeatedly until "LAN" appears on
the front panel display.
4. Press the "LAN" SELECT.
The LAN setup Menu appears.
5. Press the "DIAGNOSIS" SELECT.
In ten and several seconds after "DIAGNOSIS" is selected
(display remains unchanged), result of "DIAGNOSIS" is
displayed. Confirm that result of "DIAGNOSIS" is OK.
If it shows NG (No Good), take a remedial action as described
below.
(1) IP Assign
OK IP address is assigned correctly.
NG Illegal address has been assigned.
[Remedial action to take when result of "DIAGNOSIS"
shows NG (No Good)]
Compare the specific InWall Unit with other InWall Units that
are known-to-be-good within the same LAN.
• If the other InWall Units that are known-to-be-good within
the same LAN work normally, the Ethernet-related parts of
the NG Unit are suspected to be defective.
SECTION 4
CONFIRMATION OF NETWORK SETTING
(2) IP Conflict
OK IP address has no conflict.
NG Two or more Units are using the same IP address.
[Remedial action to take when result of "DIAGNOSIS"
shows NG (No Good)]
If result of "DIAGNOSIS" shows NG, the IP address of the NG
Unit has conflict with the IP address of other Units or other
equipment.
To resolve IP address conflict:
1. Set IP ADDRESS Settings of all InWall Units to Auto.
2. When the network equipment that are connected to the same
network as the NG InWall Unit, need to set their IP addresses
statically, perform the followings (such as printer etc.):
• If IP address can be changed from the network equipment:
Change the IP address of the network equipment so that the
IP address stays within the static IP region.
• If IP address cannot be changed from the network equipment:
Change the Automatic Assignment Region of the router side
by changing the Starting IP Address value and the Maximum
number value of DHCP of the router side so that it does not
have conflict with the InWall Unit.
(3) Cable Connect
OK Ethernet cable is inserted normally.
NG Ethernet cable is not inserted normally.
[Remedial action to take when result of "DIAGNOSIS"
shows NG (No Good)]
Disconnection, un-insertion or loose connection of the Ethernet
cable is probable.
• Reconfirm the wiring.
• The straight cable of 100 Mbps must be used.
IF result of the LAN Setup Diagnostics function shows OK,
You need not to perform the remaining sections that follow.
DVP-NW50
17
Advertisement
Table of Contents
