Straight Or Circular Machining - Siemens SINUMERIK 840D SL Operating Manual
Hide thumbs
Also See for SINUMERIK 840D SL:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Parameters
Slot side compensation •
D
8.7.7
Straight or circular machining
When you want to perform straight or circular path movements or machining without defining
a complete contour, you can use the functions "Straight line" or "Circle" respectively.
General sequence
To program simple machining operations, proceed as follows:
● Specify the tool and the spindle speed
● Program the machining operation
Machining options
The following machining options are available:
● Straight line
● Circle with known center point
● Circle with known radius
● Helix
● Straight line with polar coordinates
● Circle with polar coordinates
If you want to program a straight line or a circle using polar coordinates, you must define the
pole first.
If you use a straight or circular path movement to move the tool into the retraction zone
specified in the program header, you must also move the tool out again. Otherwise a
collision could occur as a result of the traversing movements in a subsequently
programmed cycle.
Milling
Operating Manual, 02/2012, 6FC5398-7CP40-3BA0
Description
on - only for "Cylinder surface transformation yes"
Activates slot side compensation.
off - only for "Cylinder surface transformation yes"
•
Deactivates slot side compensation.
The selection for "slot side compensation" depends on the transformation type.
Offset to programmed path - only for "slot side compensation on"
CAUTION
Programming technological functions (cycles)
8.7 Additional cycles and functions in ShopMill
Unit
475
Advertisement
Table of Contents
