Table of Contents
Advertisement
(
b) Set the ink filter as follows. (Piping joints D is on the right.)
(
c) Fill the reservoir with new ink.
(d) Insert the tip of the print head into a beaker.
● Prepares for bending of the ink stream.
Refill the IJ printer with ink
4
● When Start/Continue is pressed on the screen shown below, refilling of the lines with ink
begins.
● After a while, ink is ejected from the nozzle. Check the position of the ink stream.
Circulation control
Process：Ink filter replacement
Operation guide
Confirm the ink filter is set at the right position.
Press [Start/Continue].
● To abort the sequence, press the Abort key, and follow the on-screen instructions.
After aborting, you are returned to the "Circulation control" screen.
● When you have aborted the sequence, select the "Ink refill" from the "Circulation control"
screen and perform it.
● If the following message is output during ink refill, the system will automatically stop.
"Failure was detected in level sensor, pump or solenoid valve.
When ready, press Start/Continue ."
Press Start/Continue key, select "Ink refill" on "Circulation control" screen and execute refill.
If the same message appears again, contact your nearest local distributor.
Piping joints(D)
Ink filter
[Service ]
Com=0
2015.07.07 12:45
Ink Drainage
Filter rep.
Ink refill
Abort
Start/Continue
●Replacing the ink filter 6-20
Hide quick links:
Advertisement
Table of Contents
Related Manuals for Hitachi IJ RX2
Related Products for Hitachi IJ RX2
- Hitachi IJ PH
- Hitachi IJ UX
- Hitachi IJ UX2
- Hitachi IPJ-AW250N
- Hitachi Innovate iPJ-AW250NM
- Hitachi IC25N040ATCS04-0 - Travelstar 40GN 40GB UDMA/100 4200RPM 2MB 2.5" IDE Hard Drive
- Hitachi IC25N080ATMR04-0 - 3E034 - Dell 80GB Laptop Hard Drive
- Hitachi IC25N040ATMR04-0 - Travelstar 40GB Laptop Hard Drive 9.5mm 2.5 Inch Notebook HDD