Removing The Doors - Electrolux icon Use And Care Manual
French door bottom freezer/refrigerator
Hide thumbs
Also See for icon:
- Use and care manual (60 pages) ,
- Use & care manual (34 pages) ,
- Manual (4 pages)
Table of Contents
Advertisement
Removing the Doors
10
Getting through narrow
spaces
If your refrigerator will not fit through an
entrance area, you can remove the doors.
Check first by measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord
is unplugged from the wall outlet.
2 Open the freezer drawer and remove
the toe grille (see "Installation" section).
3 Remove any food from the door
shelves and close the doors.
To remove the top hinge covers:
1 Remove the two screws from each
cover over the top door hinges.
2 Lift inside edge of hinge cover and tilt
back.
Top Hinge
Cover
Hinge
Screws
Multi-wire
Cables
Leave
Hinge
With
Door
Rear
Cover
Screw
Ground
Top
Screw
Hinge
NOTE
DO NOT remove the ground screw from
hinge.
Front
Cover Screw
Front
Cover Screw
Top Hinge
Cover
Hinge
Screws
Two Wire
Cables
To remove the refrigerator doors:
1 Trace lightly around the door's top
hinges with a pencil. This makes
reinstallation easier.
2 Disconnect the harness by grasping
both sides of the connector firmly,
depress the latch, and pull apart.
Remove the two screws from the top
hinge. Lift the door off of the bottom
hinge and set it aside.
Rear
Cover
Screw
Ground
Screw
Top
3 Detach the water tube from the
Hinge
connector located behind the
refrigerator and pull the tube back out
to the front of the unit. The connector
Water
releases when you press inward on
Line
the outer sleeve while pushing the
tube toward the connector then while
continuing to hold in the sleeve, pull
the tube away.
Use care while pulling the water tube
from the unit to be sure that you do not
kink the tube.
Leave
Hinge
With
Door
NOTE
Press
Press
Water
Line
Approximately
5 Feet
Hide quick links:
Advertisement
Table of Contents
