To Stop The Engine; To Spray; Spraying Procedure; Cleaning After Completion Of Spraying - Husqvarna 321S15 Operator's Manual

Hide thumbs Also See for 321S15:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
IMPORTANT
• If the rope is pulled continuously with the choke closed,
the spark plug may become ! ooded and the engine
may fail to start. If so, you should " rst remove the
spark plug and dry the electrodes, then repeat the
starting procedure.

To stop the engine

WARNING
• Stop the engine immediately in the event of an emer-
gency.
1. Lower the throttle lever (12) fully and cool the engine
down for 1-2 minutes at low speed.
2. Hold down stop switch (11) on the left side of the spray-
er frame until the engine has come to a complete stop.
12
11
IMPORTANT
• Except for an emergency, avoid stopping the engine
while pulling the throttle trigger.

To spray

WARNING
• Please use correctly, observing the precautions in
this manual.
• Before lifting the sprayer onto your back, check that the
sprayer tank cap and fuel tank cap are tightly closed.
• When spraying, do not point the nozzle at your face,
or at other people, animals, etc.
• If the sprayer is tilted too much, chemical ! uid or fuel
may leak out through the air holes in the cap. When
using, always try to maintain an upright posture.
IMPORTANT
• If the sprayer tank becomes empty while spraying,
reduce the engine to low speed immediately. Empty
running of the engine may cause the spray pump to
break.
• Please avoid using multiple nozzles, jet nozzles,
or other nozzles that give a large spray volume, as
spraying ef" ciency is sometimes impaired owing to
insuf" cient pressure.

Spraying procedure

1. Start the engine,
2. Lift the sprayer onto your back.
3. Adjust the carrying band to a suitable length for car-
rying.
4. Increase the engine speed,
5. Open the cock valve (3). Chemical ! uid starts to spray
out from the nozzle in the form of mist.
6. When stopping work, close the cock valve (3) fully and
reduce the engine speed.
b
b
3

Cleaning after completion of spraying

1. Loosen the ! uid drain cap , transfer the chemical ! uid
left inside the tank into a suitable container, and pro-
cess appropriately with all due consideration to safety.
2. Pour about 5 litres of clean water into the sprayer tank,
spray through the nozzle for 2-3 minutes, and drain
the water left inside the tank.
321S15/25
a
a. open
b. close
GB-13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

321s25

Table of Contents