Table of Contents
Advertisement
Solutions to Common Problems
Before you call for service, review the following list. It may save you time and expense. Possible solutions are provided with the
problem listed:
Problem
Poor baking results
Oven does not operate
Oven light does not work
Flames inside oven or smoking from
oven vent.
Self clean does not work
Oven racks discolored or do not
slide easily
Oven smokes excessively when
broiling
Oven control panel beeps and
displays any F or E code error
Soil not completely removed after
self clean
Convection fan does not rotate
Surface element is too hot or not hot
enough
•
Many factors affect baking results. Use proper oven rack position. Center food in the
oven and space pans to allow air to circulate. Preheat oven to the set temperature
before placing food in the oven. Try adjusting the recipe's recommended temperature or
baking time. See
"Adjusting Oven Temperature"
hot or cold.
•
The time of day is not set. The oven clock must first be set in order to operate the oven.
•
Be sure oven controls are set properly. See
on
page 15
and review instructions for the desired cooking function in this manual.
•
Service wiring is not complete.
•
Be sure the oven light is secure in the socket. See
page
30.
•
Excessive spills in oven. Grease or food spilled onto oven bottom or oven cavity. Wipe
up excessive spills before starting oven. If flames or excessive smoke are present when
using broil, see
"Setting Broil"
•
Oven control not set properly. Review Self Clean section.
•
Oven racks left in oven cavity during self clean. Always remove oven racks from oven
cavity before starting a self clean cycle. Clean using a mild abrasive cleaner following
manufacturer's instructions. Rinse with clean water, dry, and replace in oven.
•
Incorrect setting. Follow broiling instructions in Setting Broil on page 21.
•
Meat too close to the broil element. Reposition broil rack to provide proper clearance
between the meat and broil element. Remove excess fat from meat. Cut remaining fatty
edges to prevent curling.
•
Grease build up on oven surfaces. Regular cleaning is necessary when broiling
frequently. Grease or food splatters will cause excessive smoking.
•
Oven control has detected a fault or error condition. Press STOP to clear the error code.
Try bake or broil function. If the F or E code error repeats, turn off power to appliance,
wait 5 minutes and then repower appliance. Set clock with correct time of day. Try bake
or broil function again. If fault recurs, press STOP to clear.
•
Self Clean was interrupted. Review Self Clean instructions.
•
Excessive spills on oven bottom. Clean before starting self clean.
•
Oven door is open. Convection fan will turn off if oven door is opened when convection
is active. Close oven door.
•
Incorrect surface control setting. Adjust power level setting.
33
Solution
on
page 25
"Minimum and Maximum Control Settings"
"Replacing the Oven Light"
on
page
22.
Before You Call
if you feel the oven is too
on
- Quick Links:
- Solutions to Common Problems
Hide quick links:
Advertisement
Table of Contents
