Table of Contents
Advertisement
(2)
Operation Procedure
START
Following two methods are available for starting debugger.
(1)
Turn on power switch of MAIN UNIT without media setting in
drive "A".
start and it successively indicates
bugger command entry.
(2)
Press |STOP| key when running.
played in hexadecimal with four digits following "0".
CRT display shows
of each content is not always given on the left side or the
^-display area of CRT screen.
COMMANDS
B (Boot)
B [<N>][D]<CR>
Initial boot is performed with the floppy disk drive "A".
to , , 0".
If D has been designated, a debugger returns into initial
boot.
D (Display Memory)
D[W]<ADDR>[,<ADDR2>]<CR>
Contents of respective addresses from <ADDR> to <ADDR2> are dis
played in word or byte unit.
contents of <ADDR> are displayed.
concerned are displayed, prior to the display.
At this CRT display gives the message of debugger
for command entry.
If <ADDR2> is omitted, address
7-18
and waiting for de
Contents of CS and IP are dis
Initial display
Both segment and address
Then,
N is fixed
Advertisement
Table of Contents
