Bop-2; Saving Drive Data On A Rom - Siemens G120P Manual
Variable speed drive
Hide thumbs
Also See for G120P:
- Operating instructions manual (496 pages) ,
- Instruction manual (100 pages) ,
- Technical manual (98 pages)
Table of Contents
Advertisement
Commissioning
3
Operator panels
3.1.2.2
Function
Status
Command source
Manual
Drive state
Ready
JOG function
Active
Fault or alarm display
Fault or
alarm
3.1.3
22
Siemens AG
Button
Function
–
Pressing and holding down the button (> 3 s) or pressing it briefly twice:
The motor coasts to a standstill
Pressing the button: Toggling between external command sources and the
BOP-2 as command source.
–
MANUAL means: Manual control using the IOP buttons
–
AUTO means: The drive responds to external control commands (e.g.
fieldbus or terminals)
You can also toggle between MANUAL and AUTO mode when the motor is
running.
Screen symbols
Symbol
Remark
No symbol is displayed if AUTO mode is activated
Steady-state symbol, does not rotate
Is displayed if the JOG function is activated
Saving drive data on a ROM
This option allows you to transfer all the drive data from the drive's internal memory
(RAM) manually to the non-volatile memory (ROM). This is necessary if changes
have been made via the STARTER commissioning software or if the IOP is in
"Save to RAM" mode.
IOP
1. Select Options > Save RAM to ROM.
2. Confirm with OK.
BOP-2
1. Select Options > RAM to ROM.
Flashing symbol
–
There is a fault present.
–
The drive stops. Clear the fault.
Permanent symbol
–
There is an alarm (e.g., overtemperature)
–
The drive keeps running.
CM2G5111en
2014-05-16
Hide quick links:
Advertisement
Table of Contents
