Specifications; Standard Accessories; Optional Accessories (Sold Separately) - Hitachi H 45MR Handling Instructions Manual
Hide thumbs
Also See for H 45MR:
- Safety instructions and instruction manual (52 pages) ,
- Handling instructions manual (46 pages) ,
- Technical data and service manual (26 pages)
Table of Contents
Advertisement
Available languages
Available languages
English
PRECAUTIONS ON USING DEMOLITION HAMMER
1. Wear ear protections
Exposure to noise can cause hearing loss.
2. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
3. Do not touch the bit during or immediately after
operation. The bit becomes very hot during operation
and could cause serious burns.
4. Before starting to break, chip or drill into a wall,
floor or ceiling, thoroughly confirm that such items
as electric cables or conduits are not buried inside.
SPECIFICATIONS
Voltage
Power input
Full-load impact rate
Weight (without cord, side handle)
* Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Case ............................................................................. 1
(2) Bull Point (SDS max shank) ....................................... 1
(3) Side Handle ................................................................. 1
(4) Hexagon Bar Wrench (for 6mm screw) .................... 1
(5) Hexagon Bar Wrench (for 5mm screw) .................... 1
(6) Hexagon Bar Wrench (for 4mm screw) .................... 1
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES (SOLD
SEPARATELY)
Crushing
(1) Bull Point
Total length: 280 450mm
Asphalt Cutting
(1) Cutter
Surface Roughing
(1) Bushing Tool
20
(2) Shank
5. Even when the switch is on, the monitor is running
and the tool head is pressed to the demolition
surface, the demolition hammer sometimes does not
start operating. In these instances, turn the switch off,
press the tool head against the demolition surface
again, and turn the switch on and off. This should
start the demolition hammer operating. Repeat this
procedure for several minutes, and the demolition
hammer will heat, after which it will operate when
switched to ON-LOCK.
230V
950W*
3000min –1
5.9 kg
Tamping
(1) Rammer
Groove digging and edging
(1) Cold chisel
Overall length: 280 400 mm
Scooping Work
(1) Scoop
Hammer Grease A
500g (in a can)
70g (in a tube)
30g (in a tube)
Optional accessories are subject to change without notice.
(2) Shank
Advertisement
Table of Contents
