D-Link DAP-3662 Quick Installation Manual page 5
Wireless ac1200 concurrent dual band outdoor poe access point
Hide thumbs
Also See for DAP-3662:
- User manual (94 pages) ,
- Quick installation manual (32 pages) ,
- Manual to install the firmware (5 pages)
Table of Contents
Advertisement
Available languages
Available languages
STEP 5: Connect the AP to Your
Network
AP
LAN1 (PoE)
A
P+DATA OUT
PoE Injector
POWER IN
DATA IN
C
B
Router or Switch
A. Connect the Ethernet cable (connected
to the AP in STEP 1) from the AP to the
"P+DATA OUT" port on the PoE Injector.
B. Connect an Ethernet cable from a router/
switch or PC to the "DATA IN" port on the
PoE Injector.
C. Attach the power adapter to the connector
labeled "POWER IN" on the PoE Injector,
and attach it into an electrical outlet.
Configuration
If you are configuring the AP locally, connect a
PC to the PoE Injector "DATA IN" port using an
Ethernet cable.
A. Assign a static IP address to your PC which
is in the same network segment with the
device. As the default IP address of this
unit is 192.168.0.50, you may choose any
address from 192.168.0.1 to 192.168.0.254,
except 192.168.0.50.
B. Open
a
web
browser
http://192.168.0.50. Enter admin as your
username and leave the password blank to
log into the web UI. Now you can configure
the AP via web UI.
D-Link DAP-3662 Quick Install Guide
Computer
and
go
to
5
- Quick Links:
- Quick Installation Guide
- Technical Support
Hide quick links:
Advertisement
Table of Contents
