Table of Contents
Advertisement
FM antenna
The FM indoor antenna
lead wire is sufficient to receive
most local FM broadcasts
and should be connected
to the
rear FM ANT terminal.
Extend the antenna
lead wire as
straight as possible and, while listening to the sound from
the system,
secure
it in a position
where the best FM
reception is found.
Infringe areas, or where reception
is distorted or noisy, an
FM outdoor antenna (not supplied)
should be connected
instead of the FM indoor antenna lead wire. The terminals
will accept 75-ohm coaxial cable,
AM antenna
The AM loop antenna is sufficient to receive most local AM
broadcasts.
Assemble the loop antenna.
Unwind the antenna wires (about 3 turns), then connect
them to the AM LOOP ANT. terminals.
Place the loop
antenna in a position which yields the best AM reception,
or attach it to a wall or other surface as shown.
upplied)
NOTES:
To minimize noise...
- Keep the speaker
wires,
power
cord
and all other
system connection
cables away from the antennas.
- Do not place the antenna close to a TV or speaker.
Video equipment
input jacks
(VIDEO)
Connect a cable (not supplied) from the output jacks of the
video equipment
to these jacks.
Speaker
terminals
(SPEAKERS)
Connect
the speaker
wires to these terminals.
The red
terminals
are (+) positive and the black terminals
are (-)
negative,
NOTE:
Use speakers with a minimum impedance
of 8 ohms, To
achieve proper stereo reproduction,
identical connec-
tions must be made at the speakers
and the amplifier,
Power cord
Connect the power cord to an AC wall outlet. If the unit will
not be used for a long time, disconnect
the AC plug from
the wall outlet.
NOTE:
Before plugging the power cord into an AC outlet, make
sure that all the connections
have been made.
-4-
Advertisement
Table of Contents
