Configuring Acl-Based Nat Server; Configuring Ds-Lite Nat444 - HP FlexNetwork MSR2003 Configuration Manual
Flexnetwork msr router series
Hide thumbs
Also See for FlexNetwork MSR2003:
- Configuration manual (350 pages) ,
- Command reference manual (471 pages) ,
- Manual (73 pages)
Table of Contents
Advertisement
Step
6.
Configure load sharing
NAT Server.
Configuring ACL-based NAT Server
ACL-based NAT Server is an extension of common NAT Server. Common NAT Server maps the
private IP address of the internal server to a single public IP address. ACL-based NAT Server maps
the private IP address of the internal server to a set of public IP addresses defined by an ACL. If the
packet's destination IP address matches a permit rule, it is translated into the private IP address of
the internal server.
To configure ACL-based NAT Server:
Step
1.
Enter system view.
2.
Enter interface view.
3.
Configure ACL-based
NAT Server.
Configuring DS-Lite NAT444
DS-Lite NAT444 is configured on the AFTR's interface connected to the external network. DS-Lite
NAT444 supports only dynamic NAT444. DS-Lite NAT444 uses an IPv6 ACL to identify packets to be
NATed.
To configure DS-Lite NAT444:
Step
1.
Enter system view.
2.
Create a NAT address
group, and enter its view.
3.
Add a public IP address
range to the NAT
address group.
4.
Configure the port range
for the public IP
addresses.
5.
Configure port block
Command
nat server protocol pro-type global
{ { global-address | current-interface |
interface interface-type interface-number }
{ global-port | global-port1 global-port2 } |
global-address1 global-address2 global-port }
[ vpn-instance global-name ] inside
server-group group-number [ vpn-instance
local-name ] [ acl { acl-number | name
acl-name } ]
Command
system-view
interface interface-type interface-number
nat server global { global-acl-number |
name global-acl-name } inside
local-address [ local-port ] [ vpn-instance
local-name ]
Command
system-view
nat address-group
group-number
address start-address
end-address
port-range start-port-number
end-port-number
port-block block-size
136
Remarks
By default, no load
sharing NAT Server
mapping exists.
You can configure
multiple load sharing
NAT Server mappings on
an interface.
Remarks
N/A
N/A
By default, no ACL-based
NAT Server mapping exists.
You can configure multiple
NAT Server mappings on an
interface.
Remarks
N/A
By default, no NAT address group
exists.
By default, no public IP address range
exists in the NAT address group.
You can add multiple public IP address
ranges to an address group, but they
cannot overlap.
By default, the port range is 1 to 65535.
The configuration takes effect only on
PAT translation mode.
By default, no port block parameter
- Quick Links:
- Configuring Ip Addressing
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
