Table of Contents
Advertisement
Chapter 5. Key Telephone Features
•
FF2: Flash Key Operation
•
FF3: Flash on PROG (Recall)
Considerations
•
You can send a longer or shorter flash signal, depending on whether you use the FLASH or
PROG key (flash tone lengths are set for the FLASH and PROG keys through system
programming).
Flexible Function Keys
CPC-96, CPC-288, and CPC-576 All Versions
Description
You can assign frequently used functions to programmable keys on key phones, DSS/72 consoles, and
EM/24 consoles. All keys not already assigned as line or speed dialing keys are available for
programming.
You can store either Fixed Feature codes or Flexible Feature codes in an FF key. (The LED of the
Flexible Function [FF] key will not light when digits are stored in the key.) Fixed Feature codes are
hard-coded and cannot be changed. Most features; however, can also be assigned flexible codes
according to the System Dial Plan. This allows the flexible codes to be changed in the dial plan
without having to re-program extensions.
When a flexible code is programmed into an FF key or soft key, the System translates the flexible
code into the fixed code. You can use either the Fixed Feature code or your System's Flexible Feature
code when programming FF keys. Table 13 on page 154 reflects both Fixed Feature codes and the
System defaults for Flexible Feature codes.
Operation
To assign Fixed Feature codes to an FF key:
1. Lift the handset or press the ON/OFF key.
2. Press the PROG key.
3. Press the FF key to be programmed.
4. Press the REDIAL key.
5. Enter the code to be programmed. (See Table 13 on page
154.)
6. Press the HOLD key.
7. Repeat steps 2-6 to program additional keys.
8. Replace the handset or press the ON/OFF key.
152
Action
DBS 576 (USA), Revised 6/11/98
Section 700 - Operation
Result
Intercom dial tone
F displays
Enter Function# displays
Programmed code displays
Programmed function name displays
576-13-700
Advertisement
Table of Contents
