Table of Contents
Advertisement
Quick Links
e
Ultra Quiet Bath Fan User's Guide
Item Stock Number(s): BF230UQ, BF270UQ, BF375UQ
IMPORTANT INSTRUCTIONS -
OPERATING MANUAL
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED.
PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
When using electrical appliances, basic precautions should always be followed to reduce
the risk of fire, electric shock and injury to person, including the following:
1. Read all instructions before installing or using
exhaust fan.
2. Use this unit only in the manner intended by the
manufacturer. If you have questions, contact the
manufacturer.
3. Before servicing or cleaning the unit, switch power
off at service panel and lock the service disconnecting
means to prevent power from being switched on
SAVE THESE INSTRUCTIONS
210572117 Rev. B 5-06
a
GENERAL SAFETY INFORMATION
accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
4. Installation work and electrical wiring must be done
by qualified person(s) in accordance with all applicable
codes and standards, including fire-related construction.
5. Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of
www.geelectrical.com
BF230UQ, BF270UQ, BF375UQ
1 of 8
Advertisement
Table of Contents
Related Manuals for GE BF230UQ
Summary of Contents for GE BF230UQ
-
Page 1: Important Instructions
BF230UQ, BF270UQ, BF375UQ Ultra Quiet Bath Fan User’s Guide Item Stock Number(s): BF230UQ, BF270UQ, BF375UQ IMPORTANT INSTRUCTIONS - OPERATING MANUAL READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE. -
Page 2: Installation Instructions
GENERAL SAFETY INFORMATION kept to a minimum, and that insulated hard ducting be used. Larger duct sizes will reduce noise and (Continued) airflow restrictions. This fan will require at least 10" fuel burning equipment to prevent back drafting. Follow of clearance in the ceiling or the heating equipment manufacturer’s guideline and wall, and will mount through safety standards such as those published by the National... - Page 3 1. Connect the ducting to the fan’s duct collar (Figure 6). Secure in place using tape or screw clamp. Always Bracket duct the fan to the outside through a wall or roof cap. Ducting Housing Duct Collar Joist Figure 3 1c.
- Page 4 4. Carefully tuck wire back inside wire compartment and replace wire compartment cover securing with Plug the screw that was removed earlier. Tabs SECTION 5 Completing the Installation Hex Nuts 1. If the fan’s blower assembly was removed during the wiring process, reinstall the blower by reversing Figure 8 the directions in Section 4 (Wiring) , Step 1b .
-
Page 5: Troubleshooting Guide
SECTION 6 Use and Care CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE SERVICING THE UNIT. 1. Cleaning the Grill: Remove grill and use a mild detergent, such as dishwashing liquid, and dry with a soft cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING POWDERS. -
Page 6: Warranty
God. This warranty contains the sole and exclusive warranty of GE for claims based on defects in these products. Upon the expiration of the warranty period, all such liability shall terminate. There are no other warranties, whether written, oral, implied or statutory. -
Page 7: Replacement Parts Diagram
REPLACEMENT PARTS DIAGRAM Qty. Description Replacement Part # Qty. Description Replacement Part # Fan Housing 5S1202044 5S2202014 Mounting Bar 5S1202045 Motor - 210 CFM 5S2202024 Nuts 5S1202041 Motor - 310 CFM 5S2202025 Metal Collar 5S5202007 Motor Plate 5S2202020 Bushing 5S5202003 Screw 5S2202027 Spring... - Page 8 210572117 Rev. B 5-06 8 of 8...