NEC Xen IPK Programming Manual page 87

Hide thumbs Also See for Xen IPK:

Table of Contents

1. If 00 (Not Set) is programmed, no trunks are accessed for this priority setting.

2. If Route Advance Block Numbers are assigned and a line key is pressed or an Access Code is dialled, the system

starts searching for an idle line in a specified group (beginning with the Trunk Group assigned priority 1).

3. If all CO/PBX lines are in use, the line with the next highest priority is seized.

4. Route Advance Block Number Access Codes are defined in Memory Block 1-1-46 Access Code (1-Digit) Assignment

or Memory Block 1-1-47 Access Code (2-Digit) Assignment.

1-1-30, Route Advance Block Assignment

Programming Manual

Chapter 1 – 67

Chapters

Table of Contents