Table of Contents
Advertisement
2
1
Figure 13
1. Tailgate latch rope
Starting Instructions
1. Place all controls in disengaged or off position.
2. Move throttle lever midway between SLOW and FAST
position.
3. Move choke lever to ON position.
Note: Choke not required when starting a warm engine.
4. Insert key into ignition switch and rotate it clockwise to
start the engine. Release key when engine starts.
Regulate the choke to keep engine running smoothly.
Important
To prevent overheating of the starter motor,
do not engage starter longer than 10 seconds. After 10
seconds of continuous cranking, wait 60 seconds before
engaging starter motor again.
5. Move throttle lever to desired engine speed.
6. Pull flap lever as far forward as possible.
7. Push rake lever to the rear as far as possible.
Note: Do not allow sweeper to stand still with rake
engaged as turf damage may occur.
Stopping Instructions
1. Move throttle lever to "SLOW" position.
2. Move ignition switch to "OFF" position. Remove key
from switch to prevent accidental starting.
Important
To stop sweeper in an emergency, move
ignition switch to "OFF"position.
Operating Tips
• Before starting to sweep, survey area to determine the
best direction to sweep.
2. Jack handle
14
Note: To maintain a straight line when sweeping, sight of
an object in the foreground.
• Always try to make a long, continuous run with a slight
overlap on the return run.
• On turf areas, the flex tip reel will pick up twigs,
clippings, leaves, pine needles and cones, small debris
(beverage cans, small bottles, paper plates, etc.).
• The rake teeth are made of flexible nylon and easily
changed. To prevent damage, the rake is protected from
solid obstructions by spring action. The nylon teeth will
not mar bronze, stone markers, sidewalks or pavement.
• Because of its unique design, the sweeper also grooms
the turf. The flex tip reel combs through and lifts grass
for a uniform cut when mowed. As it cleans, the light
scarifying action increase water and pesticide
penetration, thus reducing the need for renovation.
Important
Do not make sharp turns when using the
thatching reel as damage to turf may occur.
Important
Do not operate sweeper while reel is turning
and in the raised position. Damage to the rake and tires may
result if teeth come in contact with tires.
Caution
This product may exceed noise levels of 85 dB(A)
at the operator position. Ear protectors are
recommended, for prolonged exposure, to reduce
the potential of permanent hearing damage.
• To empty hopper, pull tailgate latch rope.
Inspection And Cleanup After
Operation
• When sweeping has been completed, thoroughly clean
and wash the machine. Air dry hopper. After cleaning, it
is recommended that the machine be inspected for
possible damage to mechanical components and blower.
These procedures will assure that the machine will
perform satisfactorily during next sweeping operation.
Important
When towing sweeper for long distances,
fasten gauge wheel arm securely to sweeper frame with
transport hooks. Should gauge wheel arm fall to ground,
damage to sweeper may occur.
Advertisement
Table of Contents
