Belt Maintenance
Servicing the Drive Belt
Checking the Drive Belt
Service Interval: After the first 8 hours
Every 200 hours
1. Position the sprayer on a level surface, set the
parking brake, move the range selector to the Neutral
position, stop the pump, stop the engine, and remove
the ignition key.
2. Rotate and inspect the drive belt for excessive wear
or damage. Replace the belt if necessary.
Figure 63
1. Drive belt
2. Primary clutch
Replacing the Drive Belt
1. Rotate and route the belt over the secondary clutch
(Figure 63).
2. Remove the belt from the primary clutch.
3. Place the new belt over the primary clutch.
4. Rotate and install it over the secondary clutch.
Adjusting the Steering Pump
Belt
Service Interval: After the first 8 hours
Every 100 hours
The belt should flex 1/4 inch (5 mm) when 5 lb of force
(22 N) is applied midway on the top span.
1. Park the machine on a level surface, set the parking
brake, turn the ignition off, and remove the key.
3. Secondary clutch
2. Loosen the steering pump mounting bolts
(Figure 64).
1. Steering pump belt
2. Steering pump
3. Move the pump until the belt flexes 1/4 inch (5 mm)
with 5 lb. of force (22 N) then tighten the mounting
bolts, starting with the bolt closest to the engine
crankshaft.
53
Figure 64
3. Steering pump mounting
bolts