Front Door (Driver And Passenger Side), Rear End Door / Trunk Lid Request Switch Inspection; Steering Lock Unit Removal And Installation; Steering Lock Unit Inspection - Suzuki SX4 Service Manual
Hide thumbs
Also See for SX4:
- Owner's manual (47 pages) ,
- Owner's manual (18 pages) ,
- Owner's manual (16 pages)
Table of Contents
Advertisement
Front Door (Driver and Passenger Side), Rear
End Door / Trunk Lid Request Switch Inspection
1) Remove front door trim, rear end door trim or trunk
lid trim.
2) Disconnect request switch connector.
3) Check for continuity between terminals "1" and "2" at
each switch position as shown below. If check result
is not as specified, replace.
Request switch specification
ON position (request switch pushed): Continuity
OFF position (request switch released): No
continuity
[A]
[B]
[D]
S7RW0AA506002
1
2
2
1
I6RW0BA50012-01
Keyless Start System:
[C]
[A]: Front door request switch (driver and passenger side)
[B]: Rear end door request switch (Hatchback)
[C]: Trunk lid request switch (Sedan)
[D]: Request switch connector (viewed from harness side)
Steering Lock Unit Removal and Installation
For removal and installation, refer to "Steering Lock
Assembly (Ignition Switch) Removal and Installation in
Section 6B".
Steering Lock Unit Inspection
Check key reminder switch and ignition knob switch in
steering lock unit for operation referring to "Ignition
Switch Inspection in Section 9C".
10E-30
[D]
2
2
1
1
I6RW0BA50013-01
S7RW0AA506003
S7RW0AA506004
Advertisement
Chapters
Table of Contents
Troubleshooting
