Installation Instructions (Power Supply) - Bosch MIC612 Operation Manual
Hide thumbs
Also See for MIC612:
- Operation manual (92 pages) ,
- Installation manual (80 pages) ,
- Brochure & specs (9 pages)
Table of Contents
Advertisement
20
en | Install the MIC (standard) PSU
Notice!
Do not connect MIC IR units to a MIC PSU with the heater option enabled as this can damage
the cameras. Ensure that an IR power supply is used with a MIC IR camera unit. Heaters are
available for MIC612 cameras only.
Caution!
!
Bosch recommends using an uninterruptible power supply (UPS) in connection with a MIC
camera/PSU installation.
Notice!
To maintain the IP rating of the power supply enclosure, install only listed or recognized
conduit hubs or fittings with the same environmental rating as the enclosure in compliance
with the installation instruction of the hub or fitting.
Notice!
Refer to the MIC Series Power Supply Installation Manual included with the PSU for full details
on installing a MIC Series PSU and connecting to a MIC Camera.
5.9
Installation Instructions (Power Supply)
To install the power supply unit (PSU), follow these steps:
1. Select a secure installation location for the PSU. Ideally, this is a location where the device
cannot be interfered with either intentionally or accidentally.
Bosch recommends using an environmentally suitable, lockable equipment cabinet.
2. Loosen the four (4) captive Phillips head screws on the top of the lid of the power supply
enclosure. Lift the lid and set it upside down next to the enclosure.
Notice!
Do not stretch or cut, or otherwise disturb, the earth core cable (shown in the figure below)
to the inside of the lid and to the earth termination post.
3. Locate the four (4) mounting holes of the power supply enclosure.
Figure 5.5: Holes for screws for mounting enclosure mounting; holes for screws for enclosure lid
Number
1
2
4. Drill four (4) holes in the mounting surface for the mounting anchors appropriate for M6
screws (not supplied).
2016.03 | 2.2 | F.01U.249.416
Description
Hole for mounting screw in enclosure
Hole for lid screw in enclosure
Operation Manual
MIC612 Thermal Camera
Bosch Security Systems
- Quick Links:
- Camera Setup
Hide quick links:
Advertisement
Table of Contents
