5.1.14
Finisher related service call
[CB10] Transport motor abnormality
MJ-1025
Is the stack feed roller (upper) home position sensor (PI12) working properly?
NO
YES
Is the wiring between the finisher controller PC board and feed motor (M1) correct?
NO
YES
Try turning the stack feed roller (upper) shaft by hand. Does the stack feed roller (upper)
move up/down normally?
NO
YES
Try replacing the feed motor (M1). Is the problem corrected?
YES End.
NO
Replace the finisher controller PC board.
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
Replace the sensor.
Correct the wiring.
Fix the mechanism.
5 - 61
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
TROUBLESHOOTING
5