Table of Contents
Advertisement
Programming Initial T1 Network Options
1. If you are installing the T1 while upgrading to a new DBS release, perform
Address
Options
2. Enter the system configuration.
Address
Options
Page 66
the "New Function Reset" command.
Note: You must perform the reset command if you're upgrading to a
completely new release, but not if you're upgrading to a point release. For
example, if you're upgrading from Version 3.10 to Version 4.00, you need
to perform the reset. However, if you're upgrading to a point release (4.06
to 4.07), you do not need to perform the reset.
FF1 8# 1# (0-1)#
0=Do not perform new function reset
1=Perform new function reset
FF1 8# 4# 1# 1# (0-8)#
0=DBS 40
1=DBS 72
2=DBS 96
3=DBS 40 + DBS 40 (T1 must be in the slave cabinet.)
4=DBS 72 + DBS 40 (T1 is not supported.)
5=DBS 72 + DBS 72 (T1 must be in the slave cabinet.)
6=DBS 96 + DBS 40
7=DBS 96 + DBS 72
8=DBS 96 + DBS 96
Note: The above command requires a system restart to take effect.
T1 Networking - Revised April 2000
Quick-Start Programming
DBS-2.3/9.2-540
Advertisement
Table of Contents
