Installation Guide
Wallplate installation
Pull at bottom to remove thermostat
from wallplate.
HIPS
PULL HERE
Drill 3/16" holes for drywall. Drill 7/32" holes for plaster.
Wall anchors
CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power before beginning
installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not
place the old control in the trash. Contact your local waste management authority for
instructions regarding recycling and proper disposal.
69-1929EFS—01
Remove the wallplate from the
thermostat as shown at left, then
follow directions below for mounting.
1. Pull wires through wire hole.
2. Position wallplate on wall, level and mark
hole positions with pencil.
3. Drill holes at marked positions as shown
below, then tap in supplied wall anchors.
4. Place wallplate over anchors, insert and
tighten mounting screws.
M29389
Wire hole
2
Mounting screws
MCR29390