Table of Contents
Advertisement
7.1.1
Menu 1 "Time/Date"
Engineer-PIN
1 = Time/Date
2 = Tamp.Reset
3 = Test
4 = Change PIN
5 = Printer
6 = Service
7 = Remote
8 = Edit
9 = Cct Off
7.1.2
Menu 2 "Tamp.Reset"
Engineer-PIN
1 = Time/Date
2 = Tamp.Reset
3 = Test
4 = Change PIN
5 = Printer
6 = Service
7 = Remote
8 = Edit
9 = Cct Off
7.1.3
Menu 3 "Test"
Engineer-PIN
1 = Time/Date
2 = Tamp.Reset
3 = Test
4 = Change PIN
5 = Printer
6 = Service
7 = Remote
8 = Edit
9 = Cct Off
Submenu
"1=Print"
Operation by the Engineer
Menu item 1 "Time/Date" complies with the function of menu
"10=Time/Date" in access level 1 (see chapter 6.3.10).
Menu item 2 "Tamp.Reset" complies with the function of menu
"12=Tamp.Reset" in access level 1 (see chapter 6.3.12).
Menu 3 "Test": In the test menu, a one-man inspection can be undertaken
and the result can be documented on a connected printer (serial Interface
Module L208/V2.24).
1=Print
2=Circuits
3=Sounders
4=Strobe
5=L240/B/BS
6=System
In submenu "1=Print" the printer interface is switched on or off. The print
parameters must be set beforehand in menu "5=Printer". All test results can
be output on the printer interface and stored with the system documentation.
After the test, the printer interface should be switched back on. A serial
Interface Module L208/V.24 and a serial printer are required for printing.
Alternatively, the serial print data can be "read", processed and printed out
on a PC or Laptop with the Interface Module L208/V.24 via a serial interface
(e.g. COM1) (see chapter 14).
Print
Off
36
Advertisement
Table of Contents
