Additional Information; Finalizing The Configuration - D-Link DWC-1000 Quick Installation Manual

Wireless controller

Hide thumbs Also See for DWC-1000:

User manual (390 pages)

Reference manual (146 pages)

Quick installation manual (53 pages)

Table Of Contents

Table of Contents

Available languages

To establish a console connection:

1. Plug the RJ-45 connector of the supplied

RJ-45 to DB-9 cable directly into the console

port on the Wireless Controller.

2. Connect the other end of the cable to a terminal

or to the serial connector of a computer

running terminal emulation software. Set the

terminal emulation software values as follows:

Baud rate: 115200

Data bits: 8

Parity: None

Stop bits: 1

Flow control: None

3. Connect the Wireless Controller following the

instructions in the "Connecting Power and

Turning On/Off" section in this guide, then

switch on your device. The boot sequence will

be displayed on the terminal.

4. Once the boot sequence is completed, the

command prompt will be displayed and the

device is ready to be configured.

Finalizing the Configuration

After initial setup, you should refer to the additional

documentation found in PDF format on the

accompanying master CD for more information on

how to begin to configure the DWC-1000 device.

D-Link Wireless Controller User Manual

This document describes the general operation

and control of the Wireless Controller firmware

which drives and controls the Wireless Controller

series hardware. It includes examples of how

to carry out typical administrative tasks such as

setting up Rogue AP detection and how to use the

Wireless Controller in various scenarios.

6  D-Link Wireless Controller

D-Link Wireless Controller CLI Reference Guide

This document describes all available text-based

commands that can be used on an RJ-45 to DB-9

Console or SSH interface to configure the Wireless

Controller.