Table of Contents
Advertisement
1J-8 Charging System:
3) After loosening generator bracket bolts (2) and pivot
bolt (3), adjust belt tension to specification described
at step 2) by loosening / tightening generator adjust
bolt (1).
4) Tighten generator bracket bolts and pivot bolt as
specified torque.
Tightening torque
Generator bracket bolt (a): 25 N·m (2.5 kgf-m,
18.0 lb-ft)
Generator pivot bolt (b): 50 N·m (5.0 kgf-m, 36.0
lb-ft)
5) Check belt tension for specification after turning
crankshaft two rotations clockwise.
6) Tighten generator adjusting bolt (1) as specified
torque.
Tightening torque
Generator adjusting bolt (c): 7 N·m (0.7 kgf-m,
5.0 lb-ft) by the specified procedure.
1, (c)
2, (a)
3, (b)
7) Connect negative cable at battery.
Water Pump / Generator Drive Belt Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) If vehicle equipped with A/C, remove compressor
drive belt before removing water pump belt (1). Refer
to "Compressor Drive Belt Removal and Installation
in Section 7B" or "Compressor Drive Belt Removal
and Installation in Section 7B".
3) Loosen drive belt adjusting bolt (2) and generator
pivot bolt (3).
4) Loosen generator adjusting bolt (4), and then
remove water pump belt.
Installation
Reverse removal procedure for installation noting the
following.
• Adjust belt tension referring to "Water Pump /
I5RW0C160007-01
Generator Drive Belt Tension Inspection and
Adjustment" and "Compressor Drive Belt Inspection
and Adjustment in Section 7B" or "Compressor Drive
Belt Inspection and Adjustment in Section 7B".
4
2
3
S7RS0B1A06004
1
I6RS0C1A0002-01
Hide quick links:
Advertisement
Chapters
Table of Contents
