Table of Contents
Advertisement
4. Drop the rear of the tube down, slide the tube back
and lift the tube out.
Removing the water inlet valve assembly:
Note: The water valves and water valve
harness connectors are color
coded; red, green and blue. When
reconnecting, match the color on
the harness connector to the color
of the valve.
1. Disconnect the washer from the electrical supply
and the hot and cold water hoses.
2. Remove the top panel, water valve and overflow/vent
grommet and the overflow/vent tube.
3. Unplug the wiring harness from the valves and the
temperature sensor.
Note: The water valve harness has locking plugs.
4. Remove the (2) screws, one on each side, holding
the water inlet valve assembly to the detergent
dispenser housing.
84
- Quick Links:
- Service Manual
Hide quick links:
Advertisement
Table of Contents
