EXTERNAL TOOL PARTS FIG. 1 Definitions: Safety Guidelines The definitions below describe the level of severity for each signal D51276 15G. Angled Finish Nailer word. Please read the manual and pay attention to these symbols. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
FIG. G IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY D WALT power source for this tool. Danger of explosion and/or • Make sure hose is free of obstructions or snags. TOOL, CALL US AT: 1800 654 155 (Aust) or 0800 339258 (NZ). serious personal injury may result.
Page 4
allowed to recontact work surface before trigger is FIG. M Your risk from these exposures varies, depending on FIG. R The gray trigger with imprinted on the side, (Cat.# released an unwanted fastener will be fired. how often you do this type of work. To reduce your D510023 kit) is the single sequential action trigger and exposure to these chemicals: work in a well ventilated causes the tool to operate in this mode.
TO INSTALL AN AIR FITTING Using the bump action trigger, two methods are available: place actuation WARNING: Lock off trigger, disconnect air line from tool and remove and bump actuation. 1. Wrap the male end of the fitting with sealing tape prior to assembly to fasteners from magazine before making adjustments or personal injury eliminate air leaks.
Daily Maintenance Chart 3. Release pusher from behind nails. Recommended accessories for use with your tool are available at extra cost from your local service center. If you need any assistance in locating any 4. Push down front latch (J) then pull up to open front door (K). ACTION Drain compressor tanks and hoses daily.
TROUBLESHOOTING GUIDE Compressor will be sufficient for tools at all production rates. MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW. FOR MORE SERIOUS OR PERSISTENT PROBLEMS, CONTACT A D WALT SERVICE CENTER OR CALL 1800 654 155 (Aust) or 0800 339258 (NZ) WARNING: To reduce the risk of serious personal injury, ALWAYS disconnect air from tool before all repairs.